
Footprint
Tyvek 75x230 cm (for 1 person)
In stock
Repair kit that allows you to patch a sleeping pad in just a few minutes. Suitable for self-inflating and inflatable NeoAir sleeping pads from Therm-a-Rest. The kit contains: 6 gel adhesive dots, 3 transparent self-adhesive patches, and 3 alcohol pads for cleaning the surface of the sleeping pad.
Inflate the sleeping pad to the maximum. Submerge it underwater and observe if any bubbles are escaping from any part. You can do this either at home in the bathtub or outside in a stream. Mark the hole with tape and continue searching.
The second option for finding a hole is to wet a sponge with a bit of dish soap and gradually wipe the sleeping pad with soapy water. In the spots where the sleeping pad has holes, bubbles will form.
Clean the surface around the hole with an alcohol pad. Once the area dries, open the valve and release all the air from the sleeping pad. Apply the gel dot to the hole. Remove the paper from the clear patch and stick it onto the gel dot. Press down firmly and push out all the air from under the patch. Allow the glued area to dry for at least 10 minutes. Then you can inflate the sleeping pad again.

If there’s one brand that sets the standard for comfortable sleep in the outdoors, it’s Therm-a-Rest. This legendary brand is renowned primarily for its sleeping pads, which are among the lightest in the world. One of the cornerstones of Therm-a-Rest’s philosophy is manufacturing in their own factories in the USA or Ireland. They stand firmly behind their products, offering a lifetime warranty against manufacturing defects and flaws.
More about the brand
Therm-a-Rest Permanent Instant Field Repair Kit
If you're not sure which size or colour to pick, or you have another question, email us. We're here for you.